![]() ![]() ![]() You'll need a pair of 1/2" NPT x 1/2" Tube Compression fittings to connect to the tubing.Ģ. If you already have 1/2" couplings welded in, that puts female 1/2" NPT threads on the inside. Understand that these fittings are NOT INCLUDED with the coil.ġ. SOME of the options are shown in the alternate picture views of the boil. The minimum port to port distance we recommend is 10" but you can stretch the coil to make it up to 14" if you desire large gaps between coils.įirst, there are a lot of ways to get a HERMS coil into a vessel and there are pros and cons like any other vessel bulkhead. However, if you have an application that would make better use of having the coil ends 90 degrees off axis from the bulkheads, such as using 90 degree compression fittings, you may request that we cut the leads off flush with the coil. This configuration works with most of the install options you would want. The result is a much easier install as the springiness of the coil allows for movement to line up to the bulkheads with ease. This coil WILL fit into a converted 1/2BBL keg as long as the hole in the top is at least 12" in diameter.Īs pictured, our coils feature 90 Degree Cross Coil Bends meaning that he leads are bent approximately 90 degrees such that they cross the centerline of the coil. Due the the lead in and out stems, the smallest pot diameter it will fit into is 13" as long as the in/out fittings are above and below the coil. Our standard coil diameter is 12" outside diameter and the resulting coil is approximately 50 feet long at 9" tall. Our HERMS coils are made from 304SS 1/2" OD x. ![]()
0 Comments
Leave a Reply. |